TS-TPI

Turbine Pump Interface

The TS-TPI turbine pump interface provides a communication link for FE Petro intelligent pump controllers to communicate faults to enabled devices. This link allows the INCON ATG to include the reporting of submersible pump conditions to a monitoring party or to the station operator. Also, by integrating the intelligence of these two systems, the ATG can keep the station pumping fuel without service calls during several events that normally would result in down time and lost fuel sales. The TS-TPI is a standard internal option on the fuel management system consoles, not available on the TS-750 or Colibri.

Highlights
Specs
Order Info
Downloads
  • Highlights

    • In dual storage tank installations where two submersibles are used for one product grade with a single line, the ATG will always start the pump in the tank with the highest product level.
    • INCON ATG can be programmed to respond to faults in the submersible pumping system.
    • Automatic reset of the dry running fault in the submersible pump controller.
    • Disables the submersible pump in the event of high water levels.
    • Remote monitoring of the entire fueling system.
    • Communication of pump diagnostic faults to remote monitoring party.
    • Standalone TS-TPI can be mounted in a location convenient to on-site personnel.
    • In one product grade dual tank installations with two submersible pumps discharging into a single discharge line, the second pump starts directly upon the shutdown of the first upon any shutdown fault. Within moments, the fault is reported to the monitoring party.
  • Specs

    System Requirements

    TS-TPI integrated into TS-LS300 AutoLearn™ line leak detection console.

    • INCON TS-1001 or TS-2001 ATG console with version 3.5 software or higher.
    • INCON TS-LS300 line leak detection console.
    • FE Petro smart controller model STP-SCI, STP-SCIII or MagVFC™.
    • For remote communication capabilities, System Sentinel™ version 3.1 software or higher or System Sentinel AnyWare™ version 1.0 or higher.

    For TS-TPI standalone option,

    • INCON TS-1001 or TS-2001 ATG console with version 3.5 software or higher.
    • TS-TPI module.
    • FE Petro smart controller model STP-SCI, STP-SCIII or MagVFC™.
    • For remote communication capabilities, System Sentinel™ version 3.1 software or higher, or System Sentinel AnyWare™ version 1.0 or higher.

    Configurations

    • Standalone: TS-TPI turbine pump interface module.
    • Included in AutoLearn™ TS-LS300: TS-TPI turbine pump interface module included in all TS-LS300 AutoLearn™ line leak detectors.
  • Order Info

    ModelDescription
    TS-TPITurbine pump interface
    • Note: Not available with the TS-750.
  • Downloads