The Side Seal Adapter is designed to give flexibility to top seal drop elbows. Your 4" top seal delivery elbow can now be used on a side 4" seal fill adapter. You don’t have to bring a separate side seal elbow, which reduces cost and the number of fittings required on your truck. Two lever clamps secure the adapter to the station’s side seal fitting and allow a 4" elbow to attach to the adapter. Special locking rings prevent accidental cam arm release during filling. Cast aluminum makes the side seal adapter light and strong. The specially designed seal gives you the added insurance that no leaks will occur.
APT® secondary test boots are designed for testing the integrity of secondary contained flexible piping when using APT® clamshell fittings. Each boot has an air chuck for applying air pressure to the secondary containment jacket. Placing a boot on each end of the secondary containment jacket forms an airtight chamber for testing. After the testing is completed, slide the boots back on the pipe to open the secondary system. The boots remain on the pipe available for future testing as required by local regulations.
EBW® product shear valves immediately stop product flow in the event of fire or collision at the dispenser. A patented adapter shears upon impact, causing the poppet to seal on the valve body, preventing fuel spillage. If fire occurs, a fusible link releases the fulcrum arm, engaging the poppet.
Standard features include a 100 mesh tube strainer, a dust cap assembly and a 6-1/2' static discharge ground wire. 1-1/4" and 1-1/2" models have an aluminum discharge tube with a knurled area for hand assembly; the 1" model has a brass tube standard. Dashpot construction ensures smooth opening, shockproof closure and maximum flow. Nozzle can be built to military specifications, consult factory for details.
With the PetroTite Standard and Optimum fusion chambers the riser section electrofuses to the base, removing the need for multiple bolt holes and foam gaskets in this area, therefore dramatically reducing the number of potential leak paths. With its simplified assembly, this electrofusion system also reduces the installation time. Welding of the chamber can be performed using UPP electrofusion equipment in approximately six minutes. Once welded and cooled the base and riser of the OCH models become one homogeneous unit, with no mechanical joints and no leak points. The chamber can then be vacuum tested to ensure that it is 100% leak-tight. The Optimum chamber is available with either Deep or Shallow bases, and both will allow for a very easy installation of pipework before the riser is fused into place.
The DC400 Dispensing Cutoff System is a stand-alone, solid state two-part system which includes a controller and sensor, designed to automatically shut down product flow if liquid is detected inside containment spaces. Ideal for retrofit applications, the DC400 allows for easy compliance with new and evolving regulations, without the added expenses of shutting down your site to break concrete for new conduit and wiring installation. The DC400 can be mounted inside any turbine sump to provide complete pump shut down or mounted directly into dispenser sumps, allowing only the effected dispenser to be shut down as liquid is detected.
APT tank fitting adapters provide a high quality, cost-effective way to mount tank sumps to a standard 4" NPT tank opening or 6" NPT tank opening. The bright zinc plated cast iron construction is not only strong, but corrosion-resistant. The TFA-400-II and TFA-600 are easy to install and their single hole style mounting allows sumps to be rotated to properly align pipe entries.
The wall transition sleeve is a practical, environmentally sound solution for below ground generator or boiler applications that pass through the walls of buildings or concrete structures. Piping enters the sleeve through APT’s special flexible entry boots. The wall transition sleeve is an economical alternative that allows a straightforward installation with no tools.