The EBW AST spill container gives overflow protection to fill and vapor return risers on an aboveground storage tank. Its 7-1/2 gallon capacity prevents potential environmental problems by containing fuel overfill spills during fill-up.
This watertight, locking fill cap consists of a sturdy brass body with an attractive grey, epoxy coated, cast iron cap. Holes are uniformly located around the edge of the cap so that it may be locked in any position. Furnished with a Buna-N gasket.
Steel Manway Covers are available in round or square options, 18" and 24" diameters, and are engineered and tested to meet or exceed H20 and HS20 load ratings.
APT bulkhead boots boast an enlarged gasket area to seal against the sump wall and incorporate the proven advantages of the APT standard flexible entry boot seal. The bulkhead boot requires only a single hole to be drilled for installation, reducing labor time and cost. APT offers a complete line of sizes for ½" through 2½" single and secondary contained pipe. The 1½" through 2½" sizes are also available in a ducted boot version to accommodate the use of APT DCT-400 corrugated ducting for easy retractability.
APT® tank manway adapters permit tank sumps to be mounted directly to a tank’s 22" or 24" manway.
APT™ brand rigid entry boots allow you to connect electrical conduit to containment sumps with a significant reduction in installation time, while also completely removing exposed rubber from the connection. This durable entry boot requires only a single 2.75” entry hole for installation, removing the time-consuming process of drilling multiple holes for fastening purposes. A clamping nut and two clamping seals are used to compress the fitting into place against the sump wall simply by tightening it into place, providing a watertight connection between the boot and the sump surface. The same method is used to seal the pipe into place simply by tightening the integrated conduit seal nut. The interior pipe seal then compresses on to the pipe, providing another watertight connection between the boot and pipe.
EBW™ brand monitoring well cap plugs expand on the inside diameter of the screen pipe casing to form a vapor and watertight seal. An integrated locking mechanism prevents unauthorized access. The locking mechanism features a captured bolt, eliminating potential drop-out. The cap is a distinctive yellow color and features the words "Do Not Fill - Monitor Well" which is molded into the cap.
APT™ brand water-resistant tank sumps feature a water-resistant, gasketed lid with integrated hold-down toggles to prevent liquid from entering into the tank sump. Four lid toggles provide compression between the lid gasket and the riser without the need for any penetrations - eliminating potential leak paths.
SAFE-LITE FRC access covers are ultra lightweight. Engineered and tested to meet or exceed H20 and HS20 load ratings. Covers weigh almost one-third less than steel, which dramatically reduces injury potential during cover removal. Available in 12", 30", 36", and 42" sizes. The slide action cover further reduces the chance of injury by eliminating the need to bend down to remove or replace the cover.
The 4542 Series one-piece tank sump is made of high-density polyethylene with a factory installed gasket snap-on lid. The 16 side panels allow for pipe entry from virtually any direction. The 4542 Series is available in three burial depths. Each offers an optional inspection port (IP) for easy viewing of the interior of the sump without removal of the lid.