The DDS is a discriminating dispenser sump sensor which provides reliable monitoring of dispenser pans and containment sumps.
The Multiplexing Sensor Hub™ (MSH) allows station owners to add additional sensors to existing sites without having to break concrete to run new conduit and wires.
As part of the CableTight™ Wire Management System, the 32 mm Flexible Conduit System is ideal for consolidating groups of cables into single containment entry points in markets that allow flexible conduit.
HEALY™ brand ¾" low permeation coaxial vapor recovery hose is designed for use in refueling applications requiring reduced permeation rates of 10 g/m^2/day to improve air quality and emissions. This premium hose provides long-lasting service with multi-fuel compatibility.
The Corrosion Control™ Desiccant Pack provides economical proactive in-sump corrosion protection by absorbing humidity from the sump environment before it can turn into corrosion-causing moisture. Keep your system running at peak performance and avoid costly maintenance, equipment replacement, downtime, and system failure caused by excessive corrosion.
By connecting to the site’s emergency stop system, Twisted Pair Primary Dispenser Disconnects are designed to disconnect low voltage communication conductors. These conductors include dispenser data and credit card data two-wire, twisted pair circuits for a total of 4 conductors for up to 8, 12, or 16 dispensers.
Analog inventory and leak detection probes provide accurate tank level monitoring and reporting with optional leak detection capabilities. These probes employ magnetostrictive position measurement technology to accurately report inventory levels in storage tanks.
APT™ brand rigid entry boots allow you to connect electrical conduit to containment sumps with a significant reduction in installation time, while also completely removing exposed rubber from the connection. This durable entry boot requires only a single 2.75” entry hole for installation, removing the time-consuming process of drilling multiple holes for fastening purposes. A clamping nut and two clamping seals are used to compress the fitting into place against the sump wall simply by tightening it into place, providing a watertight connection between the boot and the sump surface. The same method is used to seal the pipe into place simply by tightening the integrated conduit seal nut. The interior pipe seal then compresses on to the pipe, providing another watertight connection between the boot and pipe.
Available as a factory installed option on STPAG and IST biofuel compatible submersible turbine pumps (STPs), Corrosion Control™ Advanced Protection defends STPs from accelerated corrosion.
The FE PETRO® Dispenser Hook Isolation device prevents electrical feedback between dispenser hook circuits as required by most electrical codes.