Ball float vent valves are used in conjunction with extractor vent valves in the Stage I vapor riser or tank vent lines on underground storage tanks. The ball float vent valve will restrict vapor venting should a full tank condition occur and protects against product mixing and vapor locks due to vent pipe flooding. WARNING: 308 Series float vents should not be used with suction pump systems. For use on gravity drop systems only. Do not use with pump-off unloading. Do not use with coaxial Stage I vapor recovery drop tubes.
The System Integrity Testing Kit from Franklin Fueling Systems allows tightness testing of spill containers, tank access chambers and dispenser sumps to ensure air-tight seals and peace of mind. Specific testing at critical points during the installation process ensures that all components are installed correctly and that the complete installation is leak proof, preventing the need for an expensive rework.
The fill swivel adapter helps prevent leaks caused by constant fill delivery elbow movement on the riser adapter. The top section rotates during normal deliveries, preventing the bottom section from loosening on the riser pipe which could cause a vapor or product leak around the adapter.
By connecting to the site’s emergency stop system, Ethernet Primary Dispenser Disconnects provide low voltage disconnection for dispensers that use Ethernet network cabling for primary dispenser communication. Models are available that will disconnect 1 or 2 Ethernet cables for 8 dispensers or disconnect one Ethernet cable for 16 dispensers.
By connecting to the site’s emergency stop system, Twisted Pair Primary Dispenser Disconnects are designed to disconnect low voltage communication conductors. These conductors include dispenser data and credit card data two-wire, twisted pair circuits for a total of 4 conductors for up to 8, 12, or 16 dispensers.
Accessories for fill point applications.
APT® tank manway adapters permit tank sumps to be mounted directly to a tank’s 22" or 24" manway.
The vapor swivel adapter helps prevent leaks caused by constant delivery elbow movement on the riser adapter. The top section rotates during normal deliveries, preventing the bottom section from loosening on the riser pipe which could cause a vapor or product leak around the adapter. It’s poppet design seals off the vapor path when not coupled.
The EBW Warden® is designed to provide a positive shut-off during a pressurized fill delivery on an aboveground storage tank. It eliminates spills and overfills, avoiding costly cleanup expenses and ground contamination. The Warden® is fully adjustable to provide shut-off in various height and capacity aboveground tanks. It is designed to fit into a 4" fill riser, making installation on new and existing locations simple and quick. Designed with inverted floats for use in small or large rectangular tanks. Requires 4" minimum ullage. Note: The Warden® is recommended for use with clean product only. Contaminated product may cause erratic operation or valve failure
Vented installation kit for use with the FMP-HIS-U or FMP-HIS XL-U sensor installed in a 4" (10 cm) reservoir opening on double wall fiberglass tanks. The cap is compression-fit into the riser pipe via the use of a lever.