The DC400 Dispensing Cutoff System is a stand-alone, solid state two-part system which includes a controller and sensor, designed to automatically shut down product flow if liquid is detected inside containment spaces. Ideal for retrofit applications, the DC400 allows for easy compliance with new and evolving regulations, without the added expenses of shutting down your site to break concrete for new conduit and wiring installation. The DC400 can be mounted inside any turbine sump to provide complete pump shut down or mounted directly into dispenser sumps, allowing only the effected dispenser to be shut down as liquid is detected.
The TS-RA2 is a high intensity remote audible and visible alarm unit for use with Franklin Fueling Systems Automatic Tank Gauges. The unit may be used as an overfill alarm as required by federal, state and local regulations, or as a general purpose remote alarm annunciator.
With the PetroTite Standard and Optimum fusion chambers the riser section electrofuses to the base, removing the need for multiple bolt holes and foam gaskets in this area, therefore dramatically reducing the number of potential leak paths. With its simplified assembly, this electrofusion system also reduces the installation time. Welding of the chamber can be performed using UPP electrofusion equipment in approximately six minutes. Once welded and cooled the base and riser of the OCH models become one homogeneous unit, with no mechanical joints and no leak points. The chamber can then be vacuum tested to ensure that it is 100% leak-tight. The Optimum chamber is available with either Deep or Shallow bases, and both will allow for a very easy installation of pipework before the riser is fused into place.
HEALY™ brand 900 Series EVR (enhanced vapor recovery) nozzles are the most efficient and durable gasoline nozzles on the market today. The state-of-the-art smart interface design will automatically detect whether a vehicle is equipped with Onboard Refueling Vapor Recovery (ORVR) to prevent clean air from being pulled back into the storage tank, protecting the station owner’s fuel assets.
FLEX-ING™ brand FLEX-ON™ Softwall Hoses provide a highly flexible, economical alternative to hardwall hose. Softwall hoses offer additional flexibility making them ideal for reel or retractor applications where longer hose lengths are required.
APT® secondary test boots are designed for testing the integrity of secondary contained flexible piping when using APT® clamshell fittings. Each boot has an air chuck for applying air pressure to the secondary containment jacket. Placing a boot on each end of the secondary containment jacket forms an airtight chamber for testing. After the testing is completed, slide the boots back on the pipe to open the secondary system. The boots remain on the pipe available for future testing as required by local regulations.
The transition sleeve is the practical, environmentally sound solution for above and below ground supply of generator or boiler applications from remote storage tanks. Steel piping enters the sleeve through APT special flexible double entry boots. It is an economical alternative that allows a straightforward installation with no special tools.
Brass Foot Valve: Foot valves are used to maintain the prime in suction system fuel lines. The foot valves are installed at the bottom of the suction pipe at the bottom of an underground storage tank. Single poppet foot valves are typically used where easy access to the valve is available. Double poppet models offer twice as much protection for maintaining the prime. Both 1-1/2" models can be used with EBW 320 extractor fittings. Foot Valve Extractor: The 320 foot valve extractor is designed for use with the 150 and 156 1-1/2" foot valves. This 20 lb. extractor valve provides a means to remove foot valves easily from underground storage tanks for cleaning or servicing. The 320 foot valve extractor is gasket sealed to prevent loss of prime caused by air being sucked in through the top fitting.
The HEALY™ brand 600 Series Bootless Vapor Recovery Nozzles feature a bootless design for Stage II Vapor Recovery applications. For use on new or existing vapor-ready dispensers, this nozzle features internal vapor flow control which is performed without the use of electronics or variable speed pumps installed at the dispenser.
Interface modules, dispenser interface module cables, and paper supplies.