EBW® product shear valves immediately stop product flow in the event of fire or collision at the dispenser. A patented adapter shears upon impact, causing the poppet to seal on the valve body, preventing fuel spillage. If fire occurs, a fusible link releases the fulcrum arm, engaging the poppet.
The TS-LLD line leak detector provides standalone leak detection for one line.
APT tank fitting adapters provide a high quality, cost-effective way to mount tank sumps to a standard 4" NPT tank opening or 6" NPT tank opening. The bright zinc plated cast iron construction is not only strong, but corrosion-resistant. The TFA-400-II and TFA-600 are easy to install and their single hole style mounting allows sumps to be rotated to properly align pipe entries.
HEALY™ vapor recovery break away valves provide full product and vapor shut-off in the event of a drive-off with 350 lbs of separation force. Reduce damage to the dispenser, vehicle, and forecourt with the immediate sealing of both fuel and vapor pathways. Both in-line and swivel break away valve options are certified to be reconnected in the field to help mitigate the cost of separations.
As part of the CableTight™ Wire Management System, the Rigid Conduit System is ideal for applications where local regulations specify the use of ¾" bore rigid conduit but still require a liquid-tight containment entry.
The EBW® brand sealing dip cap prevents the overflowing of a tank through uncapped tank dipstick risers. The 3" sealing dip cap incorporates a spring-loaded, self-closing internal valve which seals when the sealing cap is removed and the dipstick is not in place. This innovative safety feature provides overflow protection whether the sealing cap and the dipstick are removed, or the sealing cap is in position with an attached dipstick stored in the tank.
Based on float-switch technology and made of chemically-resistant materials, the ULS is a low-cost sensor that can be installed in sumps, dispenser pans, steel double wall tanks or other locations where the presence of liquid indicates a leak has occurred.
The DC400 Dispensing Cutoff System is a stand-alone, solid state two-part system which includes a controller and sensor, designed to automatically shut down product flow if liquid is detected inside containment spaces. Ideal for retrofit applications, the DC400 allows for easy compliance with new and evolving regulations, without the added expenses of shutting down your site to break concrete for new conduit and wiring installation. The DC400 can be mounted inside any turbine sump to provide complete pump shut down or mounted directly into dispenser sumps, allowing only the effected dispenser to be shut down as liquid is detected.
The TS-RA2 is a high intensity remote audible and visible alarm unit for use with Franklin Fueling Systems Automatic Tank Gauges. The unit may be used as an overfill alarm as required by federal, state and local regulations, or as a general purpose remote alarm annunciator.
With the PetroTite Standard and Optimum fusion chambers the riser section electrofuses to the base, removing the need for multiple bolt holes and foam gaskets in this area, therefore dramatically reducing the number of potential leak paths. With its simplified assembly, this electrofusion system also reduces the installation time. Welding of the chamber can be performed using UPP electrofusion equipment in approximately six minutes. Once welded and cooled the base and riser of the OCH models become one homogeneous unit, with no mechanical joints and no leak points. The chamber can then be vacuum tested to ensure that it is 100% leak-tight. The Optimum chamber is available with either Deep or Shallow bases, and both will allow for a very easy installation of pipework before the riser is fused into place.